Extra heavy duty arms The models below are untooled like the EL-Series arms that end in “-N ” but with the addition of a Air Tool Supply hose . These can be used with custom holders for higher torque applications...
Torque arms for fastening both horizontally and vertically with the same right angle air tool If your application requires you to drive vertical fasteners and horizontal fasteners in the same work zone and the same Right Angle tool can do...
Torque arms for fastening both horizontally and vertically with the same inline or pistol air tool If your application requires you to drive vertical fasteners and horizontal fasteners in the same work zone and the same Inline or Pistol air...
Torque arms for fastening at any angle with pistol or inline air tools Arms on this page are for holding an Inline Air Tools or Pistol Air Tools so that it can fasten in any direction, Vertical, Horizontal, up, down...
Torque arms for fastening horizontally with right angle air tools Driving horizontal fasteners with Right Angle Air Tools works well where space is limited for Pistol or Inline tools because Right Angle Tools will often fit into areas between two...
Torque arms for fastening slightly off horizontal with inline or pistol air tools All arms on this page include PT-TH (Pistol Tilt-Tool Holder). Some assembly applications have fasteners that are almost horizontal but still require a little slant. PT-TH is...
Torque arms for fastening horizontally with inline or pistol air tools All arms on this page include PS-TH (Pistol Spin-Tool Holder) for clamping any tool diameter from 1-1/8″ to 2.0″ (28.6 to 50.8mm). The models below will work with pneumatic...
Torque arm for fastening on angles off vertical with inline air tools The arm below includes our SW-TH (SWivel-Tool Holder) for fastening with Inline Air Tools mounted by the tool’s air inlet, so the operator can drive screws at any...
Torque arms for fastening vertically with right angle air tools All arms on this page include RAV-TH (Right Angle Vertical-Tool Holder) for clamping any air tool diameter from 1-1/8″ to 2.0″ (28.6 to 50.8mm). The RAV tool holder allows you...
