The arms on this page have dedicated tool adapters (holders) designed by ETA to mount specific brands and models of air tools so that they perform efficiently and safely in your assembly operation without torque reaction. You can use these...
For operations that require the assembly personnel to provide downward thrust to successfully drive screws, the ETA arms on this page can transform the production process. Sometimes it can be very fatiguing to drive self-threading fasteners, self-drilling screws or fasteners...
The first 5 arms below are designed to mount an inline pneumatic tool by your tool’s inlet port via the included 1/4 NPT hardened nipple. For small and medium inline air tools this makes a simple but effective mount that...
If your application requires you to drive vertical fasteners and horizontal fasteners in the same work zone and the same Inline or Pistol tool can do both, then the arms on this page can be an excellent ergonomic improvement. We...
If your application requires you to drive vertical fasteners and horizontal fasteners in the same work zone and the same Right Angle tool can do both, then the arms on this page can be an excellent ergonomic improvement as well...
Torque arms for fastening at any angle with pistol or inline electric tools Arms on this page are for holding an Inline Electric Driver or Pistol Electric Driver so that it can fasten in any direction, Vertical, Horizontal, up, down...
Torque arms for fastening horizontally with electric right angle tools Driving horizontal fasteners with Right Angle Tools works well where space is limited for Pistol or Inline tools because Right Angle Tools will often fit into areas between two part...
Torque arms for fastening slightly off horizontal with inline or pistol electric tools All arms on this page include PT-TH (Pistol Tilt-Tool Holder) Some assembly applications have fasteners that are almost horizontal but still require a little slant. PT-TH is...
Torque arms for fastening horizontally with inline or pistol electric tools All arms on this page include PS-TH (Pistol Spin-Tool Holder) for clamping any tool diameter from 1-1/8″ to 2.0″ (28.6 to 50.8mm). The models below will work with corded...
