If your application requires you to drive vertical fasteners and horizontal fasteners in the same work zone and the same Right Angle tool can do both, then the arms on this page can be an excellent ergonomic improvement as well...
Torque arms for fastening at any angle with pistol or inline electric tools Arms on this page are for holding an Inline Electric Driver or Pistol Electric Driver so that it can fasten in any direction, Vertical, Horizontal, up, down...
Torque arms for fastening horizontally with electric right angle tools Driving horizontal fasteners with Right Angle Tools works well where space is limited for Pistol or Inline tools because Right Angle Tools will often fit into areas between two part...
Torque arms for fastening slightly off horizontal with inline or pistol electric tools All arms on this page include PT-TH (Pistol Tilt-Tool Holder) Some assembly applications have fasteners that are almost horizontal but still require a little slant. PT-TH is...
Torque arms for fastening horizontally with inline or pistol electric tools All arms on this page include PS-TH (Pistol Spin-Tool Holder) for clamping any tool diameter from 1-1/8″ to 2.0″ (28.6 to 50.8mm). The models below will work with corded...
Torque arms for fastening vertically with electric right angle tools All arms on this page include RAV-TH (Right Angle Vertical-Tool Holder) for clamping any tool diameter from 1-1/8″ to 2.0″ (28.6 to 50.8mm). The RAV tool holder allows you to...
Torque arms for fastening vertically with dedicated holders for specific electric tools The arms on this page have dedicated tool adapters (holders) designed by ETA to mount specific brands and models of electric tools so that they perform efficiently and...
All arms on this page include either UV-TH (Universal Vertical-Tool Holder) or TUV-TH (Thin Universal Vertical-Tool Holder) for clamping any tool diameter from 1-1/8″ to 2.0″ (28.6 to 50.8mm). Most of the time vertical fasteners are driven downward, however these...
Basic Tool Arm Models WITHOUT TOOL HOLDERS or AIR FITTINGS. Add Standard or Custom Tool Holders, Fixtures, Test Equipment, Etc. EL-Series arms are meant to be used with electric tools or anything other than air tools. However, all EL-Series arms...