ETA Tool Arms: Torque arms for fastening slightly off horizontal with inline or pistol electric tools

Torque arms for fastening slightly off horizontal with inline or pistol electric tools

All arms on this page include PT-TH (Pistol Tilt-Tool Holder)  Some assembly applications have fasteners that are almost horizontal but still require a little slant. PT-TH is used for those applications requiring as much as 20 degrees below and above the horizontal plane and will clamp any tool diameter from 1-1/8″ to 2.0″ (28.6 to 50.8mm).The tilt angle limits are adjustable from 0 to 20+ degrees above and below horizontal.

The models below will work with corded and battery powered electric pistol tools and inline tools only. They will not stop the torque reaction of right angle tools.

EL-Series arms are meant to be used with electric tools or anything other than air tools. However, all EL-Series arms still require a shop air connection for the float cylinder. Our Air Cylinder gives you the smoothest float of any method and decades of life (more than 50,000,000 rundowns).The volume of air needed is very low, less than 0.03 CFM. A 1/4″ (6mm) ID hose, at 80 psi (5.5 bar) minimum, is more than enough capacity.